'} {dede:field.title/}
  • {dede:field.title/}
  • {dede:field.title/}
  • {dede:field.title/}
prevnext

3R130 Digital 3 phase Stepper Motor Driver

  •   The 3R130 digital 3-phase stepper drive is based on TI’s 32-bit DSP platform and integrated with the micro-stepping technology and the patented three-phase demodulation algorithm. With the features of low noise low vibration low heating and high-speed high torque output it allows the three-phase stepper motor to deliver full performance benefits.

      Brand: Rtelligent

      Model: 3R130

      Certification: CE Certification

      Matching motor: Nema 42/52 3 phase stepper motor

      Pulse mode: monopulse/double-pulse

      Signal level: 3.3~24V compatible; serial resistance not necessary for the application of PLC

         Power supply: 110~230V AC.

      Typical application: carving machine cutting machine screen printing device numerical control machine automatic assembly equipment

  • tel:0755-29503086
  • Product Details

Description of driver functions


Functions Description of operations
Setting of micro-stepping level number SW5-SW8, the four DIP switches, are used to select the 16 micro-stepping levels in total. Please select correct micro-stepping level according to the drive panel and ensure that the drive does not act during the setting.
Output current setting  SW1-SW4, the three DIP switches, are used to select the 16 output current levels in total. Please select correct current division according to the drive panel and ensure that the drive does not act during the setting.
Pulse smoothing and bandwidth selection The DIP switch SW9 is used to select the function of pulse smoothing of drive. “off” means this function is deactivated, while “on” means that it is activated.SW0 is used to select the bandwidth of drive. The maximum passing pulse frequency is 200KHZ when it is of and 1MHZ when it is on.
Signal interface Signal interface PUL+ and PUL- are the positive and negative terminals of control pulse signal respectively; DIR+ and DIR- the positive and negative terminals of direction signal; ENA+ and ENA- the positive and negative terminals of enable signal; ALM+ and ALM- the positive and negative terminals of alarm signal; and RDY+ and RDY- the positive and negative terminals of INPOS.
Motor interface It is recommended to the operating voltage of R130 shall be 110-230V AC and filter (EMIFILTER) shall be provided before the power supply circuit.
Power interface It is recommended to the operating voltage of R130 shall be 110-230V AC and filter (EMIFILTER) shall be provided before the power supply circuit.
Indicator Indicator The drive has two indicators: the green one, a power indicator and twinkle upon the power up of drive; the red one, a fault indicator and twinkle in case of overvoltage and overcurrent. The red indicator goes off only when the fault is removed. The fault of drive can only be removed when the drive is powered on and enabled again.


Installation dimensions of 3R130 Stepper Motor Driver  

Installation dimensions of 3R130 Stepper Motor Driver  

Installation dimensions of 3R130 Stepper Motor Driver 


Operating current setting and LED indication of 3R130 stepper Motor Driver

Operating current setting and LED indication of  3R130 stepper Motor Driver


Operating current setting and LED indication of 3R130 Stepper Motor Driver



 

Micro-stepping level setting of 3R130 Stepper Motor Driver


Micro-stepping level setting of 3R130 Stepper Motor Driver


Micro-stepping level setting of 3R130 Stepper Motor Driver
 

advisory:3R130 Digital 3 phase Stepper Motor Driver